Wiring: Vibe Pixel 144LPM RGB
May 12, 2026
Section: Basic Hardware Setup | Controller: HYP-FX-SC-DIG-M-15A (DIG-ALED) | Strip: Vibe Pixel 144LPM RGB | SKU: HYP-FX-144-RGB
Strip Overview
| Specification | Value |
|---|---|
| Easy Name | Fluid Color |
| SKU | HYP-FX-144-RGB |
| Technology | High-density discrete LEDs |
| LED Density | 144 LEDs per meter |
| Color Channels | RGB |
| Roll Length | 1 meter (3.3 ft) |
| Voltage | 12 V DC |
| Addressing | Digital, individually addressable |
| Warranty | 5 Years |
At 144 LEDs/m this strip delivers extremely smooth colour gradients and fluid-looking effects — close to the visual quality of COB while maintaining individual pixel addressability. Note the roll length is 1 meter (not 5 m like other strips).
What You Need
- HYPNOTIK FX DIG-ALED controller (HYP-FX-SC-DIG-M-15A)
- Vibe Pixel 144LPM RGB strip (HYP-FX-144-RGB)
- 12 V power supply
- Connection wire or compatible strip connector
Wiring Diagram
Terminal Connections
| Controller Terminal | Wire | Strip Pad |
|---|---|---|
+ (12 V out) |
Red |
+ / VCC
|
− (GND) |
Black |
− / GND
|
DATA |
Green / Signal |
DIN / DATA IN
|
Step-by-Step Connection
- Power off the controller and power supply.
- Identify the input end of the 144LPM strip.
- Connect +12 V →
+pad. - Connect GND →
−pad. - Connect DATA →
DINpad. - Verify connections and power on.
Firmware Settings
Go to Settings → LED Preferences:
| Setting | Value |
|---|---|
| LED Type | WS2812B |
| Color Order | GRB |
| Data Pin | GPIO 13 (default) |
| LED Count | 144 × (strip length in meters) — e.g., 144 for the 1 m roll |
Power Considerations
At 144 LEDs/m the power consumption per meter is significantly higher than the 60LPM strip. For runs longer than 1–2 meters, inject power at additional points along the strip to prevent voltage drop and colour shift. See Extending the LED Strip.
