Wiring: Vibe Pixel COB 720LPM RGB
May 12, 2026
Section: Basic Hardware Setup | Controller: HYP-FX-SC-DIG-M-15A (DIG-ALED) | Strip: Vibe Pixel COB 720LPM RGB | SKU: HYP-FX-COB-720-RGB
Strip Overview
| Specification | Value |
|---|---|
| Easy Name | Zero-Dot Color |
| SKU | HYP-FX-COB-720-RGB |
| Technology | COB (Chip-on-Board) — Zero-Dot |
| LED Density | 720 LEDs per meter |
| Color Channels | RGB only |
| Roll Length | 5 meters (16.4 ft) |
| Voltage | 24 V DC |
| Addressing | Digital, individually addressable |
| Warranty | 5 Years |
This strip is RGB-only — there is no dedicated white channel. White is produced by mixing R + G + B at full output. For a strip with a dedicated warm white channel, see the COB 784LPM RGB + 2700K.
What You Need
- HYPNOTIK FX DIG-ALED controller (HYP-FX-SC-DIG-M-15A)
- Vibe Pixel COB 720LPM RGB strip (HYP-FX-COB-720-RGB)
- 24 V power supply (HYP-FX-PS-24V-6A recommended)
- Connection wire or compatible strip connector
Wiring Diagram
Terminal Connections
| Controller Terminal | Wire | Strip Pad |
|---|---|---|
+ (24 V out) |
Red |
+ / VCC
|
− (GND) |
Black |
− / GND
|
DATA |
Green / Signal |
DIN / DATA IN
|
Step-by-Step Connection
- Power off the controller and power supply.
- Identify the input end of the strip (marked
INor with an arrow). - Connect +24 V →
+pad. - Connect GND →
−pad. - Connect DATA →
DINpad. - Verify connections and power on.
Firmware Settings
Go to Settings → LED Preferences:
| Setting | Value |
|---|---|
| LED Type | WS2812B |
| Color Order | GRB |
| Data Pin | GPIO 13 (default) |
| LED Count | 720 × (strip length in meters) — e.g., 3600 for a 5 m roll |
